Ok, so I am trying to speed up the whole process that I use to make rings.
Here are the basic timings that I have right now...
I am only posting the part that I have problems with for reasons of my own.
All times are based on 18g wire.
Deburring... (this is where things are stuck...)
5/32" ID Going on 24 hours with three different medias and it is not showing anything (1 dry w/ Walnut shell, 1 dry w/ small disk shot, 1 wet w/ small disk shot)
3/16" ID 8 hours (I am fine with this time since I can put it in overnight)
1/4" ID 8 hours (again, I am fine with this time)
So you can see where my dilemma is right now... 5/32" ID 18g isn't de